How to make an origami snail

Steps

1. 1

   Step 1

   
   Materials: 1 square sheet of paper Scissors
2. 2

   Step 2

   
   If the paper is colored on one side place the colored side face down Place the paper so that the points are on top, bottom and sides. Fold in half horizontally. Unfold.
3. 3

   Step 3

   
   Fold in half vertically. Unfold.
4. 4

   Step 4

   
   Fold the side points to the center crease
5. 5

   Step 5

   
   Bring the top point down to the bottom point to fold in half.
6. 6

   Step 6

   
   Bring the right side to the left to fold in half again.
7. 7

   Step 7

   
   Insert a finger under the top layer.
8. 8

   Step 8

   
   Push it down to the right. Press in the center and then push down the top layer.
9. 9

   Step 9

   
   Result Flip the paper over and repeat on the back side
10. 10

    Step 10

    
    Lift the left side and fold it to the right as you would a page in a book. Repeat on the back side
11. 11

    Step 11

    
    Fold and align the bottom sides along the center crease .
12. 12

    Step 12

    
    Bring the left top layer to the right as you would turning a page in a book. Repeat on back side.
13. 13

    Step 13

    
    Pull the right bottom piece up from the inside and crease See next picture for result This will be the tail of your snail
14. 14

    Step 14

    
    Repeat on the left side but make the head part point upward.
15. 15

    Step 15

    
    Make a crease as shown in the picture
16. 16

    Step 16

    
    Hold the paper so that the bottom – underside is facing you Fold down the crease you just made Now fold up the point of the flap you just folded
17. 17

    Step 17

    
    Result
18. 18

    Step 18

    
    Cut a small slit that goes from the tip only until the folded edge
19. 19

    Step 19

    
    Your snail is finished!