How to make a bracelet with a hole puncher and scrap paper

Steps

1. 1

   Step 1

   
   Materials: Scrap paper Hole puncher Elastic string for the bracelet or strong string for the necklace Needle a small piece of corrugated cardboard
2. 2

   Step 2

   
   For the bracelet cut the length of string that goes around your wrist. For a necklace the length of string must be at least long enough to go over your head easily.
3. 3

   Step 3

   
   Thread a length of string longer than the measured string so that you will have plenty of extra length to make knots at the ends.
4. 4

   Step 4

   
   Punch out lots of holes from your scrap paper.
5. 5

   Step 5

   
   Place circles on the corrugated cardboard. Punch the threaded needle as close to the center of the circles as you can.
6. 6

   Step 6

   
   Push them down near the end of the string.
7. 7

   Step 7

   
   Continue stringing the circles until you have the length of the string you measured in step 2
8. 8

   Step 8

   
   Remove the needle and tie a knot to stop the circles from moving.
9. 9

   Step 9

   
   Tie the 2 ends together with a double or triple knot and cut the string close to the knot
10. 10

    Step 10

    
    Your bracelet or necklace is ready!