How to make a holder to put your mobile phone into while it charges

Steps

1. 1

   Step 1

   
   Materials: Empty plastic bottle - a shampoo bottle was used for this guide Sharp knife Scissors Sandpaper of file Cellphone and charger Optional - decorations
2. 2

   Step 2

   
   Wash out, remove stickers and dry an empty plastic bottle. Cut along the line at the top of the front of the bottle.
3. 3

   Step 3

   
   Cut down along the sides. The amount you cut depends on the size of the bottle. In this case the cuts were made about 1/3 of the way down. Then cut across the front.
4. 4

   Step 4

   
   Cut straight to the back on both sides. Stop when you get to the back.
5. 5

   Step 5

   
   Cut upwards and around along the back.
6. 6

   Step 6

   
   Cut off any messy edges.
7. 7

   Step 7

   
   With the prongs up trace the outline of the charger plug.
8. 8

   Step 8

   
   Use a sharp point to punch a hole in the center of the outline. The hole should be big enough for your scissor to go through.
9. 9

   Step 9

   
   Use the hole as an entrance point for your scissors. Cut a little outside the line you traced.
10. 10

    Step 10

    
    Check if the hole is big enough for the plug to slide in smoothly.
11. 11

    Step 11

    
    Use the sandpaper to smooth all the cut areas.
12. 12

    Step 12

    
    Your holder is finished!
13. 13

    Step 13

    
    You can leave it as is or decorated it.